IKA Works Vacstar Digital

The four-chamber membrane vacuum pump convinces with its high suction capacity, low space requirement and high serviceability. The setting of the parameters is carried out through a rotary-push button over a digital display showing current rpm.

Automated processes are controlled with the vacuum controller VC 10, which is available as an accessory. An analogue cable which is required for connecting pump and controller is included in the delivery of the pump. Additionally it is recommended to use the VSE 1 vacuum safety emmission. It prevents that solvents are released into ambient air.

The Vacstar digital is used for dry and oil-free applications in the laboratory. The membranes of the pump are particularly chemical resistant.

Pump rate max. (50/60Hz) [m³/h]: 1.32

Pump rate max. (50/60Hz) [l/min]: 22

Final pressure without gas ballast [mbar]: 2

Suction levels: 4

Cylinder: 4

Connection diameter suction side [mm]: 8

Connection diameter pressure side [mm]: 8

Gas ballast valve: no

Input pressure [mbar]: 2 - 1030

Boiling point detection: no

Solvent library: no

Two-point control: yes

Analog speed vacuum control: yes

Speed adjustment: Turning knob

Speed range [rpm]: 285 - 1200

Display: LED

Vacuum sensor: no

Venting valve: no

Condensate trap: no

Emission condenser: no

Noise at low. pressure [dB(A)]: 54

Material in contact with medium: Al2O3; PTFE; FFPM; PPS; NBR

Housing material: alu-cast coating / thermoplastic polymer

Clean room qualified: no

Explosion proofed: no

Dimensions (W x H x D) [mm]: 150 x 375 x 370

Weight [kg]: 11.5

Permissible ambient temperature [°C]: 5 - 40

Permissible relative humidity: 80% (up to 31°C), decreasing linearly to max. 50 (@40°C)

Protection class according to DIN EN 60529: IP 20

RS 232 interface: yes

USB interface: USB-B

Analog output: no

Voltage [V]: 100 - 240

Frequency [Hz]: 50/60

Power input [W]: 130

Power input standby [W]: 3